Revisions log for Answer #2126
This is the answer to the question How do I make a cutout for a door in a load-bearing wall?
Revision 1
2022‑09‑12 14:12
Active REV1
Initial text
I can only tell you how we did it, and it turned out great. By the way, it was a DF 11.5mm brick wall, that is not these air stones, but hard stones comparable to KS. And with a 24mm wall I would have cut on both sides. there was a nice straight edge.
The vacuum was a starmix arh1635, so it wasn't a toy vacuum. The dust that was left was really minimal, especially when you saw how dusty the vacuum was when you emptied it.