We would like to clean our windows after installation!
There is, of course, the typical construction site residue. Outside – flex dust from neighbors' shingles, etc. On the inside – residue from the plumbers and electricians' bending and chiseling work. Splatter from interior plaster, screed, etc.
Now that the biggest dirty work is done, we want to check the windows and frames for scratches, etc. and clean them thoroughly.
What's the best way to do this without getting scratches?
We did it ourselves using detergent, water, scraper, plus sticker remover from the DIY store because there was a lot of residual protective film.
It's a very silly job, but you know your windows afterwards.
You have to do same as always, but using a lot of water and carefull.
And make sure you wait a few minutes after aplying sticker remover.